Weston 08-2201-W Manual de instrucciones descargar pdf (Pagina 16)

-16-

CIRCUIT BREAKER INSTRUCTIONS

PLEASE NOTE: This Grinder features an all hardened steel gear

transmission. This causes the Grinder to operate at a higher volume and

temperature than other Grinders. This is normal and will not affect the

Grinder’s performance.

This Grinder is equipped with a Circuit Breaker

as a safety precaution. If the Grinder stops running

follow these steps to remedy:

1. Turn the Grinder to the “Off” position.

2. Check the Grinder to see if there is a jam in

the Grinder Head. If there is, the jam needs to be

cleared of the obstruction as outlined in “Grinding

Tips”.

2. Press the Circuit Breaker Reset Button

(Figure 13).

3. Turn the Grinder back on and resume grinding.

4. If the Grinder still does not turn on, check that the electrical wall outlet is properly

working. Plug in another appliance to see if that appliance works from the wall outlet.

Check that the household circuit breaker has not been tripped. If none of the above

steps remedy the situation, or if the Circuit Breaker repeatedly shuts off the Grinder

contact a customer service for further assistance.

WARNING! DO NOT continue to use the Grinder if the Circuit Breaker trips

repeatedly. Continued use may cause permanent damage to the Grinder and will void

the warranty.

Circuit Breaker

Reset Button

DO NOT over-tighten the Front Ring Nut. It should be ﬁ rmly tight.

Make sure the Grinding Knife blades lay ﬂ at on the Grinder Plate.

DO NOT operate the Grinder without meat in the Head. Running the Grinder

while dry could damage the Head and Auger.

ALWAYS lubricate the Head, Grinding Plate and Grinding Knife with a food-

grade silicone spray after cleaning.

DO NOT grind bones, nuts or other hard objects.

If the Grinder Plate becomes jammed/clogged during operation, follow these

steps to restore normal output.

Turn the Grinder “OFF” and disconnect the Power Cord from the electrical outlet.

Remove the Front Ring Nut and Grinding Plate.

Thoroughly clean the Grinding Plate. Make sure all of the holes are clear.

Re-install the Grinding Plate and Front Ring Nut.

Re-connect the Grinder to the electrical outlet.

Continue with grinding.

Repeat as necessary.

GRINDING TIPS

FIGURE 13

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

Comentarios a estos manuales

Sin comentarios

Weston 08-2201-W Manual de instrucciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para Picadoras Weston 08-2201-W